Audio to sheet music: export MusicXML for MuseScore or Sibelius

MIDI is great in a DAW, but to read or print the part you want notation. ohtune can now export MusicXML, the standard file that notation programs open. Here’s how to go from a recording to a readable score, and what to expect from the beta.

The short version

  • Convert the recording on the audio-to-MIDI page (it runs in your browser; nothing is uploaded).
  • Clean up wrong and extra notes in the piano roll, then quantize.
  • Press “Export MusicXML” and open the .musicxml file in MuseScore (free), Sibelius, Dorico or Finale.

Tidy the notes before you export

Notation shows every tiny timing wobble as a dotted sixteenth or a tie, so a raw transcription looks busy. Delete the extra notes first (see the guide on removing extra notes), keep the melody only if you need a single line, and quantize to eighth notes. The tempo matters: the export uses the same tempo as the .mid, and if it’s half or double the real one, bar lines land in the wrong place.

What the export does

  • 4/4 time, notes rounded to sixteenths at the detected tempo.
  • A key signature from the notes; sharps or flats spelled to match it.
  • A grand staff (treble and bass) when the part goes above and below middle C, otherwise one staff with the right clef.
  • Long notes across bar lines are split and tied; chords stay chords.

Known limits (beta)

  • No triplets, no other time signatures, no pickup bar detection: change these in your notation program.
  • One voice per staff, so overlapping lines are written with ties rather than separate voices.
  • No PDF yet: open the MusicXML in MuseScore and print or export PDF from there.

Finish it in MuseScore

In MuseScore, use File → Open on the .musicxml file. Fix the time signature if the piece isn’t in 4/4, re-spell any odd accidentals, and add dynamics or lyrics. If the rhythms look cluttered, go back to ohtune, quantize to a coarser grid and export again; it takes a few seconds.

Convert a recording to sheet music